561 nm全固态低噪声激光器研究
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

2011年高等学校博士学科点专项科研基金联合项目(No.20112216110006)资助


Research on 561 nm all-solid-state low-noise laser
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用激光二极管端面泵浦Nd∶YAG晶体,通过LBO非线性晶体腔内倍频,利用双折射滤波器进行选频,最终获得稳定的低噪声561 nm激光输出。LBO晶体尺寸为2 mm×2 mm×10 mm,采用Ⅰ类相位匹配切割。抽运功率为4.8W时,低噪声561 nm激光最大输出功率为70 mW,光-光转换效率为1.46%。作为对比,再利用布氏片进行选频,得到的561 nm激光的噪声高于利用双折射滤波器进行选频时的噪声,实验结果与理论分析一致。

    Abstract:

    Using a laser diode end pumped Nd∶YAG crystal,LBO nonlinear crystal intracavity frequency doubling,birefringent filter(BF)frequency-selecting,a stable 561 nm laser output with low noise is obtained.The size of LBO crystal is 2 mm×2 mm×10 mm,and the crystal is cut with type Ⅰphase matching.The 561 nm laser maximum output power with low noise is 70 mW when the pump power is 4.8 W,and the optical to optical conversion efficiency is 1.4%.As a contrast,using frequency-selecting with BP,the obtained noise of 561 nm laser is higher than that by BF.The experimental results and theoretical analysis are consistent.

    参考文献
    相似文献
    引证文献
引用本文

马威,高兰兰,朱心宇.561 nm全固态低噪声激光器研究[J].激光与红外,2015,45(10):1206~1210
MA Wei, GAO Lan-lan, ZHU Xin-yu. Research on 561 nm all-solid-state low-noise laser[J]. LASER & INFRARED,2015,45(10):1206~1210

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2015-10-20
  • 出版日期: